- Changing
Modes
To switch to the chronograph mode while in normal
dime display mode, (mode hand on DV), press and hold
down button A for 3 seconds. Mode and function hands
will move to zero position
To switch back to normal time display mode from chronograph
mode, press and hold Button A for 3 seconds.
Watch switches to dive standby mode automatically
when sensor is wet. To switch back to time after dive,
press and hold button B for 3 seconds.
To call up maximum depth memory of the last dive,
while in the time or dive mode, press Button B, Depth
indicator hand will move to show the deepest point
of the last dive. Press and release button B again
to return the dive depth hand back to its previous
position.
|
- To
Set Time
Unscrew the crown by turning it in a counterclockwise
direction to release it. Pull the crown out two steps
to set the hour and minute hands.
Turn the crown to move the hands forward to the correct
time while observing the 24 hour has so as to properly
set the time for AM or PM.
Push the crown in to finalize setting.
|
|
To
Set Date
After
the correct time has bee set (24 hour hand indicating
whether time is AM or PM) and the crown is pulled
out one step (intermediate position), rotate the crown
in the counter clockwise direction to set the date.
Once time and/or date is set, push crown in against
the case and while continuing to apply pressure, turn
the crown clockwise until it is screwed tightly against
the case.
|
- Using
the Chronograph
Hold Button A down for 3 seconds while in normal time
display mode to switch to chronograph mode. Function
hand now becomes chronograph sweep second hand, mode
indicator becomes minute register hand. Small second
hand always shows actual running seconds.
Press and release Button B to start or stop chronograph.
When stopped, press Button A to reset hands to zero
position. If either of the two hands toes nor return
to the zero position, please refer to the "ALL
RESET" procedure in the instruction manual.
To return to normal time display mode from chronograph
mode, press and hold button A.
Chronograph does not operate simultaneously with time
or dive mode. If mode is switched from chronograph,
chronograph data is deleted
|
|
- Using
60-Minute Timer
Before the watch goes into dive standby mode and
before diving, make sure 'screw lock' crown is tightened
securely against the case. Watch is now ready for
diving.
Watch will automatically switch to dive standby mode
from either normal time or chronograph mode whenever
water sensor gets wet. Mode hand moves to "DV"
and depth indicator hand will move to '0' feet. (If
this does not happen, please refer to the ALL RESET
procedure outlined in the instruction manual.
To read the maximum depth memo for the last dive (after
all moisture has been removed from exterior of watch)
press button B while in time or dive mode. Depth indicator
hand will point to the maximum depth of your last
dive. Press Button B again to return to the previous
mode.
Depth meter and chronograph cannot be used simultaneously.
The elapsed time indicator (ETI) bezel ring should
be used to keep track of elapsed dive time. (See your
instruction manual for detailed information)
Maximum depth measurement is 125 feet. If diver exceeds
that depth, depth indicator hand rests on 'overzone'
mark until returning to 125 feet or less Always use
the 'buddy system' when diving. This watch is not
a substitute for a dive partner.
It is recommended that there be no divining unless
the power level indicator is at level 2*.
|
- Important
Note
Before use, please check position of function
hand (sweep second) while in the time mode. It will
be resting in one of three positions to indicate the
level of energy stored. Level 2 indicates a sufficient
charge. Level 1 indicates charging is needed and the
watch should NOT be used for diving. Level NG indicates
very low power and watch will soon stop.
|
|
